tag:blogger.com,1999:blog-8410140457122624973.post9222922344054598000..comments2023-05-01T19:14:56.840-05:00Comments on The "Arduino, Kinect and related rants" Blog: Maxbotix XL-EZ2: Ultrasonic Range FinderNMhttp://www.blogger.com/profile/03556991654093947404noreply@blogger.comBlogger3125tag:blogger.com,1999:blog-8410140457122624973.post-53738367513141534292016-09-07T02:04:39.205-05:002016-09-07T02:04:39.205-05:00Chúng tôi là nhà cung cấp hàng đầu về máy đo khoả...Chúng tôi là nhà cung cấp hàng đầu về <b> <a href="https://www.chothietbi.com/" rel="nofollow">máy đo khoảng cách</a> </b>, đo micromét, caliper điện tử, chà nhám rung máy, máy cắt sắt và nhiều hơn nữa giá cả phải chăng hơn nhiều.Anonymoushttps://www.blogger.com/profile/11510779248999921959noreply@blogger.comtag:blogger.com,1999:blog-8410140457122624973.post-21654676730249122062012-10-22T16:32:47.613-05:002012-10-22T16:32:47.613-05:00Hi Gigi. Thanks, I'm glad you found this post ...Hi Gigi. Thanks, I'm glad you found this post helpful. And apologies for the delay! Basically, it's just the following two lines you need in your main loop, but it may differ across different Arduino boards. So take this as a sample:<br /><br />void loop()<br />{<br />// for reading from the digital RX pin labelled '0' on my arduino<br />int distance = digitalRead(0); <br />Serial.println(distance); <br />}<br /><br />Also, bear in mind whether you want to use the analog or serial output from the Maxbotix sensor - because they're all on separate pins (e.g. for the one explained here, it's pin3 for analog, pin5 for serial etc.). Hope this helps!<br /><br />In case it still doesn't help, I also found this link for you to read RX channels with the Arduino: http://dduino.blogspot.de/2012/06/read-rx-channels-through-arduino.htmlAnonymousnoreply@blogger.comtag:blogger.com,1999:blog-8410140457122624973.post-67505476079942387092012-10-16T11:04:36.375-05:002012-10-16T11:04:36.375-05:00Hi, I want to tell you that you have done a very n...Hi, I want to tell you that you have done a very nice work!! I just want to ask you if you can explain the code a little bit , that I need to know what do i have to change if am not using LED and i want to write the distance result in serial monitor ? and I am using LV-1 i don't have ax only TX and RX?? can you help me please?Anonymoushttps://www.blogger.com/profile/04493297800801183116noreply@blogger.com